In the factory, precast prestressed concrete double T panels are commonly used. Long-line pedestals of 60 to 150 meters and pre-tensioning method are used to produce formwork. Steel molds or concrete tire molds can be used. The rib width, rib height, plate and the overhanging part of the plate are often made adjustable and changeable. Special molding machines can be used for pouring, vibrating and calendering concrete. The components can be maintained by circulating heat medium in the mold cavity. Using the same pedestal and formwork, prestressed or non-prestressed concrete double T-slabs of different spans and sizes can be produced. It can also be changed to produce grooved boards, or the formwork can be separated longitudinally to produce single T-slabs. One mold can be used for multiple purposes and is more flexible.

What are the specific aspects of cylinder failure caused by the gas circuit system failure of concrete mixing station?
(1) Leakage inside and outside the cylinder is caused by eccentric installation of the piston rod, insufficient lubricating oil, wear and damage of sealing rings and sealing rings, impurities in the cylinder and scars on the piston rod. The center position of the piston rod should be adjusted, the reliability of the injector should be checked regularly, and impurities in the cylinder should be eliminated in a timely manner.

(2) The output force of the cylinder is insufficient and the movement is unstable. The piston or piston rod is stuck, poor lubrication, insufficient air supply, or there is condensation and impurities in the cylinder. The center position of the piston rod should be adjusted, the reliability of the oil mist nozzle should be checked, whether the air supply pipe is blocked, and the condensate and impurities in the cylinder should be removed in time.

(3) The cushioning effect of the cylinder is not good. Due to damage to the buffer ring or damage to the adjusting screw, the sealing ring and adjusting screw should generally be replaced.
(4) The piston rod and cylinder head are damaged, usually due to the eccentric installation of the piston rod or the failure of the buffer mechanism. The center position of the piston rod should be adjusted in time, and the buffer seal ring or adjustment screw should be replaced if necessary.
